Venstar T1700 Owner's Manual download pdf (Page 9)

Thermostat Adapter Owner’s Manual (Rev 2.0+)

Page 9 of 13

ADVANCED FEATURES

Restoring Power to Thermostat Adapter

Thermostat Adapter stores all of its settings, such as Links to other INSTEON devices, with non-volatile

memory. Because settings are saved in this non-volatile memory, they will not be lost in the event of a

power failure.

In the event of a power loss Thermostat Adapter will automatically return the load to the state it had

before power was interrupted.

Resetting Thermostat Adapter to its Factory Default Settings

The factory reset procedure can be used to clear the Thermostat Adapter memory of all INSTEON Links,

set points, etc.

1) If you are using a Controller to control Thermostat Adapter, be sure to Unlink it from the Controller.

See Unlinking Thermostat Adapter from an INSTEON Controller.

2) If you are using Thermostat Adapter to control any Responders, Unlink them from Thermostat

Adapter. See Unlinking an INSTEON Responder from Thermostat Adapter.

3) Unplug Thermostat Adapter from your thermostat

• Open the cover of the thermostat

• While pressing & holding the small round button (located on the bottom center of the

thermostat), gently pull down on Thermostat Adapter

The Thermostat Adapter Status LED will turn off

4) Wait 10 seconds

5) While pressing & holding the Set button on Thermostat Adapter, plug it back into your thermostat,

making sure not to let go of the Set button

6) Continue to hold the Set button for 3 seconds and then release

The Thermostat Adapter Status LED will stay off for about 20 seconds and then turn on

The thermostat display will flash all the LCD characters three times and then return to normal

operation

The Thermostat Adapter Status LED will flicker for a few moments and then turn on solid

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Venstar T1700 Owner's Manual Page 9