Venstar T1700 Owner's Manual download pdf (Page 8)

Thermostat Adapter Owner’s Manual (Rev 2.0+)

Page 8 of 13

Reporting Changes to Compatible Automation Controller/Software

Thermostat Adapter will report the following changes to an INSTEON-compatible home automation

software once a change has been “stabilized” for at least 2 minutes:

• Temperature

• Humidity

• Thermostat mode

• Fan mode

• Set points

NOTE: Thermostat Adapter will only report changes to the last device it was Linked to, using the

instructions below. To change the interface to which you’d like the changes to be reported, follow the

“Enable” instructions with the new interface as the Responder.

While Thermostat Adapter will report to any automation controller or interface you Link to via the following

instructions, check the software’s documentation about compatibility with this feature.

Enabling Change Reports

1) Set the thermostat to Off mode

2) Press & hold the Set button on Thermostat Adapter for 3 seconds

The Thermostat Adapter Status LED will begin blinking