Venstar T1050 Owner's Manual download pdf (Page 18)

About Advanced Features & Operation

HEAT/COOL DIFFERENTIAL - The Heat and Cool setpoints will not be

allowed to come any closer to each other than the value set in Advanced

Setup step #7, on page 12. This minimum difference is enforced during

Auto-changeover and Program On operation.

Note: To increase the spread between the heating and cooling set-

points, press the MODE button until only the heat setpoint is displayed;

adjust to the desired setpoint. Press the MODE button until only the

cool setpoint is displayed; adjust to the desired setpoint. Press the

MODE button again to enter the Auto-changeover mode where both the

heat and cool setpoints are displayed.

OFF

I2:00

HEAT

COOL

ONOFF

AUTO

Fan On

Program

Locked

Setup

I8:88

Day

Night

Evening

Morning

SuMoTuWeThFrSa

OFF

I2:00

MEMORY BACKUP - In the event of a power loss, the thermostat will

retain the stored program settings without external power or batteries.

Page 17

WARNING: This will reset all Time Period and Advanced Programming to

the default settings. Any information entered prior to this reset will be

permanently lost.

FACTORY DEFAULTS -

settings back to the factory default settings, follow the instructions below.

If, for any reason, you desire to return all the stored

Place the therm-

ostat in the OFF

mode.

Press

MODE button.

While holding the

MODE button, press

and hold the DOWN

button for 5 sec-

onds. All icons will

appear on the display.

and hold the

After all of the icons

appear, release the

MODE and DOWN

buttons. Then press

and hold the FAN

button for 5 seconds.

After the letters Fd

appear on the display

(Factory Default),

release the FAN

button. Press the

MODE button twice

to return to normal

operation.

MODE

FAN

1 2 ... 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Venstar T1050 Owner's Manual Page 18

Comments to this Manuals

Related products and manuals for Thermostats Venstar T1050