Venstar T1900 User Manual download pdf (Page 65)

Page 14.3

Adjusting the Cycles Per Hour

Press the PROGRAM button to leave the Setup screens. If no buttons are

pressed, the display will leave the setup screens after 30 seconds.

PROGRAM

Press

(d1, d, 2 - 6)

The Cycles Per Hour setting may limit the number of times per hour

your HVAC unit may energize. For example, at a setting of 6 cycles

per hour the HVAC unit will only be allowed to energize once every 10

minutes. The Cycles Per Hour limit may be overridden and reset by

pressing the UP or DOWN buttons on the thermostat.

Setup

PROGRAM

MODE

Press the MODE button. While holding

the MODE, press the PROGRAM

button to enter Setup screens.

Press the MODE button repeatedly

until this setup screen appears.

Select the cycles per

hour limit.

d=cycles per hour

limit defeated.

d1=d + defeat 5 min.

compressor lockout.

Note: Press the MODE

button momentarily

to move through the

setup screens. Press

and hold the MODE

button to move back-

wards through the

setup screens.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 107 108

No comments

Venstar T1900 User Manual Page 65